#QUANTUM BRIGGS AND STRATTON ENGINE INSTALL#
#QUANTUM BRIGGS AND STRATTON ENGINE SERIES#

Do not tamper with governor springs, or other parts that will increase engine speed above specification.ДЄll engine parts, including fuel cap, spark plug, muffler, air cleaner, and covers and guards for drive components (gears, belts, shafts, couplings, etc.) must be in place before attempting to start engine. Refer to equipment manufacturerвЂ™s manual. Set engine speed to equipment manufacturerвЂ™s specification. Replacement parts must be the same model as the original.Д®nsure all wiring, including safety switches and engine shut-off components are completely installed and functioning properly.

#QUANTUM BRIGGS AND STRATTON ENGINE INSTALL#

Install muffler (and muffler deflector if used) so outlet points away from operator, fuel tank, and equipment, and so muffler heat will not damage or deform engine and components.Д®nsure all fuel lines and fittings are properly assembled and do not leak. All components must be in good condition. If the exhaust system on the old engine was supplied by the equipment manufacturer, you must transfer the exhaust system and related components (original muffler and related pipes, brackets, clamps, and shields) to the new engine. Any such modification is at the ownerвЂ™s sole risk. Do not modify the engine in any way without Briggs & Stratton factory approval. Contact your Authorized Service Dealer for assistance. Briggs & Stratton does not approve of or authorize such uses.Дo not attempt to install this engine if you do not have the appropriate tools and knowledge of small engine installation procedures. Do not use Briggs & Stratton engines on 3 -wheel All -Terrain Vehicles (ATVs), motor bikes, air craft products, or vehicles intended for use in competitive events.

#QUANTUM BRIGGS AND STRATTON ENGINE SERIES#

Note: For all Go -karts use only a model 136200 series engine, which offers improved safety and performance. Refer to the Operation & Maintenance Instructions for engine identification information. Replacement engines should be the same model as the original engine, or be the Briggs & Stratton designated replacement engine. If this engine will be used to build new equipment, contact Briggs & Stratton to ensure that the engine is appropriate for the intended use. Some engines are unique and designed for specific applications or types of equipment.

Indicates a situation that could result in damage to the engine.ДЇailure to select the correct engine could result in fire or explosion. WARNING indicates a hazard which, if not avoided, could result in death or serious injury.Д¬AUTION indicates a hazard which, if not avoided, might result in minor or moderate injury.Д¬AUTION, when used without the alert symbol, In addition, a hazard symbol may be used to represent the type of hazard.ДANGER indicates a hazard which, if not avoided, will result in death or serious injury. A signal word (DANGER, WARNING, or CAUTION) is used with the alert symbol to indicate the likelihood and the potential severity of injury. The safety alert symbol is used to identify safety information about hazards that can result in personal injury. Failure to follow instructions and safety information could result in serious injury or death. Read entire Operating & Maintenance Instructions for this engine AND the instructions for the equipment this engine powers.

NOTE: This sheet of instructions and safety information is not meant to cover all possible conditions and situations that may occur. IMPORTANT SAFETY INFORMATION AND In the USA and Canada, INSTRUCTIONS FOR our 24 hour hotline is: ENGINE SELECTION 18002333723 ENGINE INSTALLATION Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 ENGINE OPERATION Keep these instructions for future reference.Д«efore installing and operating this engine read and observe all warnings, cautions and instructions on both sides of this sheet, on the engine, and in the operating & maintenance instructions.

Quantum briggs and stratton engine